Denture Adhesive Cushions
Fittydent Denture Adhesive Cushions are specifically designed for extremely flat and narrow lower jaws, where conventional denture adhesives may not provide sufficient adhesive strength. When the denture’s contact surface is very limited, applying adhesive cream can be difficult or ineffective. The water-insoluble adhesive layer is applied to a flexible cotton fabric, making the cushions self-adhesive and easy to use.
Targeted solution. Maximum stability. Secure hold in everyday life.
lower denture
lower denture
Denture Adhesive Cushions
Fittydent Denture Adhesive Cushions are specifically designed for extremely flat and narrow lower jaws, where conventional denture adhesives may not provide sufficient adhesive strength. When the denture’s contact surface is very limited, applying adhesive cream can be difficult or ineffective. The water-insoluble adhesive layer is applied to a flexible cotton fabric, making the cushions self-adhesive and easy to use.
Targeted solution. Maximum stability. Secure hold in everyday life.
lower denture
lower denture
Brand Names |
 |
 |
 |
Available |
International | Nordic Countries/Italy | USA / GB |
Manufacturer |
Fittydent International, Vienna – Austria |
Suitable for |
Extreme flat and narrow lower jaws – even with excess saliva |
Benefits |
Waterproof, Zinc free, no animal testing – PETA certified, vegan, Self-adhesive |
Bonding Duration |
Up to 12 hours |
Amount per use |
1 Adhesive Cushion is intended for single use |
Side effects |
No incidents so far. However, in case of intolerance/hypersensitivity against one of the ingredients please stop using. Swallowing the Denture Adhesive is harmless. In the unlikely event that a serious problem develops after use, contact your doctor. Any serious incident that has occurred in relation to the device should be reported to the manufacturer and the competent authority. |
Increase or Decrease in Bonding Duration |
Denture wearers with minimal oral mucosa could experience an extended bonding duration. Excessive salivation could affect the product performance = shorter bonding. |
Removal |
The bonding become less at the end of the day and you can remove the dentures easily. |
| Removal in Exceptional Situations | If early removal is necessary, gently tilt the lower denture slightly upward at the back and release it with a gentle, controlled movement. This also applies if the adhesive strength has not decreased by the end of the day and you wish to remove the denture before going to sleep. |
Cleaning |
To remove possible residues of the water-insoluble Fittydent Denture Adhesive Cushions, we recommend using Fittydent Cleaning Tablets together with a soft denture or toothbrush.
Milky deposits on the denture may indicate that cleaning residues remain. Minimal residues on the denture, jaw or palate can also be gently removed with a small amount of cooking oil and a soft cotton cloth. |
Caution |
Do not use Fittydent Denture Adhesive Cushions in combination with other adhesive products. Not suitable for soft-lined dentures. Have the fit of your denture checked regularly by a dental professional. Keep out of reach of children. Dispose of the outer packaging, product packaging and leaflet in accordance with local regulations and the recycling symbols. |
Storage |
Store dry at room temperature! |
Instruction for Use |
Clean the denture thoroughly and dry it completely. Remove the protective films from both sides of the Fittydent Denture Adhesive Cushion. Tip: Slightly bend the cushion to make it easier to remove the protective films.
Place the Fittydent Denture Adhesive Cushion onto the lower denture and press it down carefully. Avoid eating or drinking for approximately 15 minutes.  |
Ingredients |
Polyvinylacetate, Sodium Carboxymethylcellulose, Glycerintriacetate, Petrolatum |
Brand Name
International
Nordic Countries/Italy
USA / GB
Manufacturer
Fittydent International, Vienna – Austria
Suitable for
Extreme flat and narrow lower jaws – even with excess saliva
Benefits
Waterproof, Zinc free, no animal testing – PETA certified, vegan, Self-adhesive
Bonding Duration
Up to 12 hours
Amount per use
1 Adhesive Cushion is intended for single use
Side effects
No incidents so far.
However, in case of intolerance/hypersensitivity against one of the ingredients please stop using. Swallowing the Denture Adhesive is harmless. In the unlikely event that a serious problem develops after use, contact your doctor. Any serious incident that has occurred in relation to the device should be reported to the manufacturer and the competent authority.
Increase or Decrease
in Bonding Duration
Denture wearers with minimal oral mucosa could experience an extended bonding duration. Excessive salivation could affect the product performance = shorter bonding.
Removal
The bonding become less at the end of the day and you can remove the dentures easily.
Removal in Exceptional Situations
If early removal is necessary, gently tilt the lower denture slightly upward at the back and release it with a gentle, controlled movement. This also applies if the adhesive strength has not decreased by the end of the day and you wish to remove the denture before going to sleep.
Cleaning
To remove possible residues of the water-insoluble Fittydent Denture Adhesive Cushions, we recommend using Fittydent Cleaning Tablets together with a soft denture or toothbrush.
Milky deposits on the denture may indicate that cleaning residues remain.
Clean your denture regularly and thoroughly for hygienic reasons.
Minimal residues on the denture, jaw or palate can also be gently removed with a small amount of cooking oil and a soft cotton cloth.
Caution
Do not use Fittydent Denture Adhesive Cushions in combination with other adhesive products. Not suitable for soft-lined dentures. Have the fit of your denture checked regularly by a dental professional. Keep out of reach of children. Dispose of the outer packaging, product packaging and leaflet in accordance with local regulations and the recycling symbols.
Storage
Store dry at room temperature!
Instruction for Use
Clean the denture thoroughly and dry it completely. Remove the protective films from both sides of the Fittydent Denture Adhesive Cushion. Tip: Slightly bend the cushion to make it easier to remove the protective films.
Place the Fittydent Denture Adhesive Cushion onto the lower denture and press it down carefully. Smooth out any air bubbles. Trim any excess material with small scissors if necessary. Insert the denture as usual and bite down briefly and firmly.
Avoid eating or drinking for approximately 15 minutes.
Ingredients
Polyvinylacetate, Sodium Carboxymethylcellulose, Glycerintriacetate, Petrolatum
